SpeedBox 3.0 for Bafang (3-pin connector)
PARAMETERS:
Activated by: LIGHT button / + - + -
Maximum speed: unlimited speed
Speed limit setting: yes
Display data: actual values
Compatible with motors:
Bafang Max Drive M300
Bafang Max Drive M400
Incompatible with:
SpeedBox App
displays with UART connectors
Bafang Max Drive M420
Bafang Max Drive M500
Intelligent third-generation product with the ability to adjust the speed limit of your e-bike.
The SpeedBox 3.0 tuning product allows for arbitrary configuration of electric speed limiters. After installing the tuning, you can view actual values such as maximum speed, average speed, daily mileage, and range.
How does SpeedBox 3.0 work?
You can activate the SpeedBox 3.0 on the e-bike display. After pressing the LIGHT button or ↑↓↑↓, the display will briefly show 99 km/h (62 mph) and from that moment on, you are no longer limited.
To turn off the tuning, press the LIGHT button or ↑↓↑↓ again. The display shows 25 km/h (16 mph) and the 25 km/h speed limit will be re-enabled. The e-bike works just as it did before the tuning was installed.
We are also prepared for e-bikes that do not have a classic control panel with the LIGHT button. In this case, simply use the + - + - button combination and SpeedBox will be activated. It can be deactivated the same way.
To set the maximum speed, you can switch modes three levels down and then three levels up. The current speed limit will then be displayed. To change the maximum speed, briefly press the LIGHT button or turn the wheel 360°. The last displayed limit is saved after five seconds of inactivity.
Installation
To connect the SpeedBox chip to an e-bike, we use colored connectors equipped with a key for proper connection, making the chip really easy to install. You can download instructions or watch videos that will guide you through installing SpeedBox. Removing the SpeedBox is just as easy as installing it. If you have any connection problems, do not hesitate to contact us.
If you want a SpeedBox on a new e-bike, you must first ride the bike for at least 1 kilometer.
Notice
Please note that the use of modified e-bikes on public infrastructure may conflict with current legislation in some countries. The manufacturer is not responsible for damages resulting from the use of SpeedBox products. E-bikes equipped with SpeedBox products cannot be used on roads, cycle paths, or in public areas. E-bikes equipped with SpeedBox products may only be used on your own property and solely at your own risk. The use of SpeedBox products may void your e-bike's warranty.
We recommend using additional protective gear to prevent injury.
In case of updating your e-bike software, first uninstall SpeedBox from the e-bike, update the software, and reinstall the SpeedBox.
